Geothermal Earth Loops for Tennessee Valley

In part three of our Introduction to Geothermal series, we are going to discuss geothermal loop systems and how each type works.

A geothermal loop is the series of underground pipes used to move heat to and from the earth. The pipes are formed out of high-density polyethylene to establish a durable, long-lasting system. They are fastened together using thermal fusion that will develop a bond that is far stronger than the original pipe itself. In fact, a properly installed loop can last up to 200 years.
 
There are two leading types of geothermal loop systems that are almost always used in today's installations: open loop systems and closed loop systems. Both systems have unique pros and cons for your heating or cooling solution. We at Southern Solar Systems have the knowledge and expertise on both types, and we will guide you step by step in the process of selecting the best choice for your geothermal installation.

Open loop geothermal solutions are designed to utilize the natural groundwater from under your home. Using a well, water is from an existing aquifer and moved to the geothermal heat pump where its heat is withdrawn and the water is pumped back into the ground or to a designated runoff. Since the water that you are handling is not being altered in any way, the only thing that is being returned to the ground is water that is a tiny bit warmer or cooler (depending whether you're in heating or cooling mode).

One thing to watch out for with an open loop system is water quality. Mineral build-up can develop from poor quality water. This can be attended to with an occasional cleaning. If the water in the earth has higher iron content, you will need to make sure that the discharge water is kept away from air before it is returned to prevent clogs.
 
Closed loops are just as they sound. Instead of pumping water from a well and depositing it elsewhere, water is circulated in a completely sealed circuit with a small amount of environmentally-friendly antifreeze.
 
There are two primary types of closed loop installations: horizontal and vertical. Installing the system horizontally needs quite a bit of land space. The piping is embedded in trenches between 4 and 6 feet deep and can be up to 400 feet long. If you reside on a smaller lot, the loops can be installed vertically by boring straight down using drilling equipment. This form of installation can be installed in as little as a 10ft by 10ft  area.
 
In either case, the larger the building, the larger the geothermal heat pump and loop needs to be. A good ball park figure is that for every ton of system capacity, you will need 500 to 600 feet of pipe.
 
Contact Southern Solar Systems today to find out what system options are available to you here in Tennessee Valley.